Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Junction, TX

Garage Door Installation in Junction, TX

New steel, insulated, wood-look and carriage-style doors, measured and professionally installed. Typical cost $1,200-$4,500.

Garage Door Installation is one of the most common calls we get. A technician will explain what is wrong and what it will cost before starting, and test the door before leaving. New steel, insulated, wood-look and carriage-style doors, measured and professionally installed.

Is it time for garage door installation?

  • Several damaged panels or a rusted-through door
  • No insulation in an attached or heated garage
  • An outdated look that hurts curb appeal
  • Repeated repairs on an old door

What usually causes it

  • Doors typically last 15-30 years depending on material and care
  • Storm or impact damage
  • Updating the home's look or efficiency

What you can check yourself

  • Measure the opening width and height, plus the headroom above it.
  • Decide on insulation, windows and style before choosing a model.
  • Ask whether wind-load requirements apply in your area.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle garage door installation

  1. Measure the opening, headroom and side room
  2. Help you choose material, insulation, style and color
  3. Remove and haul away the old door
  4. Install the new door, tracks, springs and seals
  5. Balance it, connect the opener and test it

Typical garage door installation prices

$1,200-$4,500Typical range, parts & labor
4-6 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Local garage door installation for Junction, TX

For Texas homes, look at insulated steel or composite doors that resist moisture, and ask whether wind-load requirements apply to your area before you choose a model.

Parts of Texas are exposed to hurricanes and tropical storms. A garage door is often the largest opening in a home, so wind-rated doors and reinforcement kits matter here, and building codes in coastal areas may require them when a door is replaced.

Hailstorms are common in parts of Texas. Hail can dent steel panels and crack windows, and thicker-gauge or insulated doors resist dents better than thin single-layer steel.

Besides Junction (ZIP code 76849), we handle garage door installation in Mason (36.8 mi), Kerrville (48.5 mi), Eden (50.4 mi) and Brady (51.6 mi). Call (833) 435-8883 to book a visit in Junction.

Garage Door Installation: frequently asked questions

How much does garage door installation cost in Junction, TX?

Garage Door Installation typically costs $1,200-$4,500 including parts and labor, and usually takes 4-6 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do garage door installation the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is garage door installation covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Texas or Junction requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Junction, TX

Skylink Opener Gear & Sprocket Replacement

Skylink makes openers and a wide range of universal replacement remotes and keypads.

Typical $125-$275

Overhead Door Off-Track Garage Door Repair

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $175-$450

Hörmann Garage Door Roller Replacement

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $150-$350

Raynor Torsion Spring Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $200-$450

Steel Garage Door Repair

Dents, rust and bent sections on steel doors repaired or replaced.

Typical $150-$600

Hörmann Garage Door Opener Repair

Openers that hum, click, reverse or won't respond, diagnosed and repaired.

Typical $125-$350

Cornell Cookson Commercial Door Operator Repair

Cornell Cookson makes rolling steel service doors, security grilles and rolling fire doors.

Typical $300-$1,200

CHI Overhead Doors Garage Door Track Repair

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $150-$400

Sommer Opener Gear & Sprocket Replacement

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $125-$275

Garage Door Tune-Up & Maintenance

A full inspection, lubrication and adjustment to prevent breakdowns.

Typical $90-$200

Raynor Opener Gear & Sprocket Replacement

Stripped drive gears replaced so the motor moves the door again.

Typical $125-$275

CHI Overhead Doors Extension Spring Replacement

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $150-$350

Garage door stuck, noisy or broken?

Talk to a garage door technician in Junction, TX now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote